9TRUNKING ZONESP LACING A D ISPATCH C ALL1 Select the desired trunking zone and a group ID.2 Press and hold the PTT switch.3 If the ìClear to Talkî tone sounds, communication is possible; start speakinginto the microphone. Release the PTT switch to receive.ï For best sound quality at the receiving station, hold the microphone approximately1.5 inches (3 ~ 4 cm) from your mouth.4 When your conversation is finished, return the microphone to its hanger.R ECEIVING A D ISPATCH C ALL1 When a dispatch call is received, the transceiver will automatically change tothe correct channel and you will hear the call.2 Readjust the volume as necessary.P LACING A TELEPHONE C ALLNote: You can only make a telephone call if the telephone service is available and you have an optionalkeypad microphone. Refer to ìDTMF CALLSî on page 12. Consult your dealer for further details.1 Select the desired trunking zone and a group ID.2 Press and hold the PTT switch for approximately 1 second to ensure aconnection.ï Confirm that there is a dial tone after releasing the PTT switch.3 Dial using the microphone keypad.ï After dialling, wait for a response from the called party.4 When the called party responds, press and hold the PTT switch and speakinto the microphone. Release the PTT switch to receive.ï Only one person can speak at a time.5 To end the call, press the # key or the key programmed as TEL Disconnect.R ECEIVING A T ELEPHONE CALL1 When a telephone call is received, the transceiver will automatically change tothe correct channel and you will hear the call.2 To respond to the call, press and hold the PTT switch and speak into themicrophone. Release the PTT switch to receive.ï Only one person can speak at a time.3 To end the call, press the # key or the key programmed as TEL Disconnect.