Kenwood TK-7150 Instruction Manual

Also see for TK-7150: Specifications Specifications Instruction manual Service manual

Contents

16■ Identification CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.Each transceiver must have its own Fleet and ID number.ï Enter a Fleet number (100 ~ 349) to make a group call.ï Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.ï Enter a Fleet number followed by an ID number to make an individual call in yourdesired fleet (Inter-fleet call).ï Select ìALLî Fleet and ìALLî ID to make a call to all units (Broadcast call).ï Select ìALLî Fleet and enter an ID number to make a call to the selected ID in allfleets (Supervisor call).Note:◆ Broadcast and Supervisor calls are programmed functions that cannot be made with akeypad.◆ The ID range may be limited by programming.S TATUS M ESSAGEYou can send and receive 2-digit Status messages (10 ~ 79) which may be decidedin your talk group. Messages can contain up to 16 alphanumeric characters.A maximum of 9 received messages can be stored in the stack memory of yourtransceiver. These saved messages can be reviewed after reception. If the stackmemory is full, the oldest message will be erased when a new message isreceived. The mail icon ( ) lights when a message is stored in the stackmemory.Note: All stored messages will be cleared when the transceiver power is turned OFF.■ Transmitting1 Select your desired zone and channel/group ID.2 Press the key programmed as Message Mode to enter Selcall Mode.3 Rotate the Selector to select the ID of the station you want to call.ï You can also enter digits by using the DTMF keypad if Manual Dial is enabled.(Press the PF1 key or the key to erase an incorrect digit.)4 Press the key programmed as Message Mode or the # key to enter StatusMode.5 Rotate the Selector to select the status you want to transmit.ï You can also enter digits by using the DTMF keypad if Manual Dial is enabled.(Press the PF1 key or the key to erase an incorrect digit.)6 Press the PTT switch to initiate the Status call.ï ìCOMPLETEî is displayed when the call has been successfully transmitted.

/ 23

Related manuals for Kenwood TK-7150