10CONVENTIONAL ZONESTRANSMITTING1 Select the desired conventional zone and a channel.ï Make sure the channel is not in use. When a channel is in use, the BUSY (green)LED will light.2 Press and hold the PTT switch, then speak into the microphone in yournormal speaking voice.ï For best sound quality at the receiving station, hold the microphone approximately1.5 inches (3 ~ 4 cm) from your mouth.3 Release the PTT switch to receive.4 When your conversation is finished, return the microphone to its hanger.R ECEIVING1 Select the desired zone and channel.2 When you hear a call, readjust the volume as necessary.2-T ONE S IGNALLING2-Tone Signalling only opens the squelch when the transceiver receives twotones corresponding to those set up in the transceiver. When the squelch opens,you will be able to hear the caller without any further action.ï When the squelch opens, the CALL icon flashes.After a correct 2-Tone signal is received and the squelch opens, pressing the keyprogrammed as Monitor will cancel the connection.If your dealer programmed Transpond for 2-Tone Signalling, the transceiverautomatically sends an acknowledgment signal to the station that called you afterreceiving the 2-Tone signal.If your dealer has programmed Tone Alert for 2-Tone Signalling, the transceiverwill emit a beep when the correct 2-Tone signal is received.To transmit a 2-Tone signal:1 While pressing the PTT switch, press the key programmed as 2-ToneEncode.2 Continue to transmit as normal.