Kenwood TK-7180 Service Manual
Also see for TK-7180: Modification InformationFunction referenceBrochure & specsSpecificationInstruction manual
                                                                                     | |
Contents
|
TK-718012CN1CN403GPS receiverVGS-18-2. Installing the GPS receiver together with the VGS-11. Remove the cabinet, top packing and shielding plate of thetransceiver.2. Remove the front panel from the transceiver.3. Attach a cushion to the bottom of the VGS-1 as shown inFigure 8-5.Note : Be sure not to cover the connector with the cush-ion.TX-RX unit (B/3)Solder landGND (GND)RXD1TXD1TXD2RXD2 (DATA OUT1)OPT1OPT3OPT4OPT55E (+5V)DTITCTLTXOAUDIHOPT2STONRXEOTXIRXEIOPT68CGPS receiver3M Double coated cushionNo. 4016 (or No. 4416)30 x 25 mm3M Double coated cushionNo. 4016 (or No. 4416)30 x 25 mmGPS receiverqwFig. 8-2Fig. 8-3Fig. 8-4Fig. 8-54. Insert the VGS-1 connector (CN1) into the TX-RX unit (B/3)connector (CN403).5. Perform step 3 to 6 of “8-1. Installing the GPS receiver”described on page 11.Note : You must setup using the KPG-89D.INSTALLATION |
Related manuals for Kenwood TK-7180
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine