TK-71803SERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and align-ment procedures contained in this manual.NOTE• If you do not intend to use the speaker 3.5-mm jack andthe D-sub 25-pin connector, fit the supplied speaker-jackcap and D-sub cap to stop dust and sand from getting in.• If the transceiver is turned ON or OFF when the power-on/off status message is enabled, the transceiver sends thestatus.GENERAL / SYSTEM SET-UPSpeakerjack cap D-subcapPower inputconnectorIgnitionsense cableAntennaconnectorMerchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingSee page 4.A personal computer (IBM PC or compatible), programminginterface (KPG-46), and programming software (KPG-89D)are required for programming.Frequency range RF power Type136~174MHz 30W KAre you usingthe remote kit?Are you usingthe ignition sense cable?Are you usingthe radio interface cable?Are you usingthe public address?Are you usingthe voice guide & storageunit?KRK-10KCT-46KCT-40KCT-36 Extension cableKGP-2AModem GPS receiverorKGP-2BModem GPS controlleror KDS-100Mobile data terminalKAP-2VGS-1YESNOYESNOYESNOYESNOYESNOSupplied microphoneDeliveryAre you usingthe external speaker?Are you usingthe keypad microphone?KES-3 or KES-5 External speakerKMC-32 or KMC-36YESNOYESNODesk top microphone KMC-9CSee page 9.See page 7.See page 7.See page 8.See page 10.(Option)(Option)(Option)(Option)(Option)(Option)(Option)(Option)(Option)(Option)SYSTEM SET-UP