Kenwood TK-7180 Service Manual

Also see for TK-7180: Modification Information Function reference Brochure & specs Specification Instruction manual

TK-718015q wSpacerSpeakerSpeaker holderre■ Installing the holder (J19-5468-03) and speakerhardware fixture (J21-8481-03)1. Insert two tabs of the holder (J19-5468-03) into the hol-lows in the top of the panel. ( q )2. Push the two tabs of the holder in on the opposite side ofthose in step 1 above and fit them into the hollow in thebottom of the panel. ( w )Note : Push in the holder until it snaps in place.3. Install the speaker holder onto the panel. ( e )Note : To improve water resistance, fit the panel into thegroove of the holder.4. Place the speaker into the speaker holder.Note : The speaker must not ride on the holder rib.5. Place the spacer on the speaker.6. Insert the hardware fixture (J21-8481-03) into the hollowof the panel as shown in Figure 7-3, then push two partsof the hardware fixture and fit it into the hollow of the topof the panel. (Fig. 7-3 r )Note : Push in the hardware fixture until it snaps in place.7. Insert the speaker connector into the display unit connec-tor (CN901).8. Place the speaker lead on the holder hook.■ D-sub cap installation procedureTo improve water resistance, fit the D-sub cap into the D-sub terminal hardware fixture of the transceiver in the follow-ing order:1. Fit the left side ( q ) of the D-sub cap into the hardwarefixture.2. Fit the right side ( w ) of the D-sub cap into the hardwarefixture.3. Fit the center ( e ) of the D-sub cap into the hardware fix-ture.Verify that the D-sub cap is in close contact with the hard-ware fixture.qweFig. 6Fig. 7-1Fig. 7-2DISASSEMBLY FOR REPAIRFig. 7-3