Kenwood TS-130S Service Manual

Also see for AT-130: Instruction manual Service manual Service manual Service manual

TS430SVADJUSTMENTS) . =in rei, Measuring point Adjust reneitem Condition ratraments| Unit | Tarminal | —Unit [Pars "| Heferencs Sperifications/Femners2) BPF-8 Disconnect |Detector, [PLL ais® [PLL T12 | Adjust T12~connectors 117 |Oscillo- 113 |T14 for wave-and J19 on the |scope, 114 | formas shownPLLunit. |Swaao at right,Connect the |generator 17 |Adjust 17 forcathode of maximum024 and D27 output.onthe PLL unitto the jumper‘wire next tothe D22 on theAF-GEN unitwith a lead.Connect thesweep genera-tor AF outputto the anode of |2433 24.58 25.03(028 on the PLLunit via a 1SpFcapacitor.Same as above3) BPF-C Disconnect con-| T15 Adjust T15~nectors J17 and 716 T17 for waveJ19 on the PLL! Tit formas shown,unit. at right.Connect the 18 | Adjust T8 forcathode of 020) meximum output Sass aaea' assand 027 on the}PLL unit to thejumper wirenexttothe D22on the AF-GENunit,‘Sweep genera-tor RF output:Same as aboveDetector input:Same as above9, VFO.MIX Disconnect Spectrum |PLL Qi6 PLL VAL Adjust for Less than —55dBspurious connector analyzer or minimum outputJ17 on the monitor at 14.99MHz.Note: This adj- |PLL unit. receiverustment should |Connect thebe done after |cathode of@ completing the |17 on theBPF-A adjust- |PLL unit to the|ment(or check), |jumper wirenext to theD22 on the AF-GEN unit.VFO scale: 250MODE:Cw.10. PLLAF Cisconnect SSG, [PLL a7® [Pie Té | Adjust fortrap connector J17 |RF VTVM J18,1P minimumon the PLL output.unit.Gannect theSSG output8.83MHz,60dB to Q7emitter on thePLL unit via a0.01uF capa-citor.35