Kenwood TS-2000 Instruction Manual

Also see for TS-2000: Instruction manual Instruction manual Service manual Specifications Service manual

Contents

Kenwood TS-2000 Instruction Manual Manual pdf 68 page image

6013 MEMORY FEATURESn Memory Scroll1 Press [M.IN] to enter Memory Scroll mode.• The memory channel that was last selectedappears.2 Turn the MULTI/ CH control, or press Mic [UP]or [DWN] to step through the memorychannels.• You can also change channels by entering a3-digit number, such as 012, using thenumeric keys, then pressing [ENT].3 To exit Memory Scroll mode, press [CLR].• The transceiver re-displays the memorychannel or VFO frequency that wasselected before you activated MemoryScroll.Note: Do not press [M.IN] again after entering Memory Scrollmode. Pressing [M.IN] results in over-writing the current VFOdata to the memory channel you selected.n Temporary Frequency ChangesAfter retrieving frequencies and associated data inMemory Recall mode, you can temporarily changethe data without overwriting the contents of thememory channel.1 Access Menu No. 06B and select ON.• Skip this step when changing only theassociated data (not the frequency).2 Recall a memory channel.3 Change the frequencies and associated data.• Use only the Tuning control to select afrequency.4 If necessary for future use, store the changeddata in another memory channel. Refer to“Channel á Channel Transfer” {page 61}.Note: Memory channel data can also be changed while usingthe TF-SET function.MEMORY-VFO SPLIT OPERATIONUnder “ENHANCED COMMUNICATIONS” {page 31},you learned about split-frequency operation using twoVFOs. Recalling a split-frequency channel is anotherway to perform split-frequency operation. If youaccess Menu No. 06A and select ON, you can alsouse a memory channel and a VFO together for thisoperation, as follows:• RX: Memory channelTX: VFO A or VFO B• RX: VFO A or VFO BTX: Memory channelTo use a memory channel for receiving:1 Access Menu No. 06A and select ON.2 Press [A/B] to select the VFO that you will use fortransmitting.• “tA” or “tB” appears to show which VFO isselected.3 Select the frequency for transmitting.4 Recall a memory channel by pressing [VFO/M].5 Turn the MULTI/ CH control to select a memorychannel to receive.6 Press [SPLIT].7 The VFO A frequency appears on the sub-display.If you want to use the VFO B frequency totransmit, press [SPLIT] again.8 Press [SEND] or Mic [PTT] to transmit on thefrequency shown on the sub display.9 Press [SPLIT] to exit the SPLIT operation.• If Split operation is still selected using VFO A orVFO B, press [SPLIT] again to exit Splitoperation.To use a memory channel for transmitting:1 Access Menu No. 06A and select ON.2 Recall a memory channel by pressing [VFO/M].3 Turn the MULTI/ CH control to select a memorychannel to transmit.4 Press [VFO/M] to return to VFO mode.5 Press [SPLIT]. The other VFO frequency appearson the sub display for transmission (Normal SPLIToperation).6 Press [SPLIT] again. The memory channel youselected in step 3 appears on the sub-display fortransmission.7 Press [SEND] or Mic [PTT] to transmit on thefrequency in the memory channel.8 Press [SPLIT] to exit SPLIT operation.