Kenwood VR-7070 Instruction Manual

Also see for VR-7070: Service manual Service manual

Kenwood VR-7070 Instruction Manual Manual pdf 4 page image

4 ENOperationWhen the STANDBY indicator is lit, the power turns ON when you pressthe POWER RCVR key on the remote control. When the power comesON, press the key you want to operate.POWER RCVR6 m• When pressing more than one remote control key successively, press thekeys securely by leaving an interval of 1 second or more between keys.Notes1. The supplied batteries may have shorter lives than ordinary batteriesdue to use during operation checks.2. When the remote-controllable distance gets shorter than before,replace both batteries with new ones.3. Placing the remote sensor in direct sunlight, or in direct light from ahigh frequency fluorescent lamp may cause a malfunction.In such a case, change the location of the system installation toprevent malfunction.Before applying the powerFCC WARNINGThis equipment may generate or use radio frequency energy.Changes or modifications to this equipment may cause harmfulinterference unless the modifications are expressly approved inthe instruction manual. The user could lose the authority tooperate this equipment if an unauthorized change or modificationis made.NOTE:This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipmentmay cause harmful interference to radio communications, if it is notinstalled and used in accordance with the instructions. However,there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:– – Reorient or relocate the receiving antenna.– – Increase the separation between the equipment and receiver.– – Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.– – Consult the dealer or an experienced radio / TV technician forhelp.For the U.S.A.Note to CATV system installerThis reminder is provided to call the CATV system installer'sattention to Article 820-40 of the NEC that provides guidelines forproper grounding and, in particular, specifies that the cable groundshall be connected to the grounding system of the building, asclose to the point of cable entry as practical.Loading the batteries1 Remove the cover. 2 Insert the batteries.3 Close the cover.• Insert two AA-size (R6) batteries as indicated by the polaritymarkings.Preparing the remote controlAs an E NERGY S TAR® Partner,Kenwood Corporation has determined thatthis product meets the E NERGY STAR®guidelines for energy efficiency.Thisproduct can save energy. Saving energyreduces air pollution and lowers utility bills.For the U.S.A.Operating range(Approx.) Remote sensorInfrared ray system