Kenwood VR-7070 Instruction Manual

Also see for VR-7070: Service manual Service manual

Kenwood VR-7070 Instruction Manual Manual pdf 40 page image

40 ENBasic remote control operations for other componentsStoring the remote control code of the othercomponentsThe remote control unit can store the remote control code of the othercomponents and you can operate the other components from the remotecontrol unit. The remote control code is stored on the key or memory ofthe remote control unit.Storing on the keyYou can store the remote control code to the key as shown below:SRCPowerTVPower5689432107Tune – Tune +DimmerBandSetupTop MenuAutoInfo / FlipInputModeLoudnessActiveEQSpeakerEQSoundToneTV Input BassBoostTVVOL4¢CH+–VOL+–Disc Skip MenuInput Sel.OSDGuideReturnExitPageTV MuteLAST / AB+ 10 + 100MultiMultiP. CallP. CallEnterTVPHONO POWERRCVRVID2VID1 DVD6CH CDDVDMDTAPE+–TUNERAV AUXVID3StereoListen ModeTHXLearnMuteDisc Sel.DSPModeNumeric keysSource keysSRC PowerReturnDisc Sel.Disc SkipCH +/–Skip ¢/4¢Rewind4Fast forward3/8Play/Pause2Flip 7StopLearnOSDMenuPage∞/51Point the infrared ray system part of another remote controlunit to the remote sensor of the remote control unit.2Press and hold the Learn key for 3 seconds until blinkstwice, then release the Learn key.3Press the numeric key to enter “9-7-5”.4Press any of the source keys (PHONO, VID1, VID2, VID3, DVD/6CH, AV AUX, CD/DVD, MD/TAPE, TV ) to select the input of thedesired remote control unit.• While in Tuner mode, learning code function will not be available.5Press the desired key of the remote control unit.• “LEARN” appears on the display.6From the remote control unit of the other source, press the keythat you want to store.• The remote control code is sent to the remote control unit.• “OK” appears when finished.• If the code cannot be stored after a few attempts, “ERROR” willappear. Repeat from step 2 onwards.6The remote control code is stored on the key of this remotecontrol unit.7Repeat step 4or 6to store additional components until allthe desired components are stored.8To exit the learning mode, press and hold the Learn key for 3seconds until blinks twice.9To clear the stored remote control code of the other sources:1 Press and hold the Learn key for 3 seconds until blinks twice,then release the Learn key.2 Press the numeric key to enter “9-7-6”.3 Press the source key, then press the stored key twice untilblinks twice.• blinks twice to indicate that the stored remote control code aredeleted.Remote controlunit of the othersource.Infrared ray system part