Setting Up a Data Pattern8You can now set the channel mode, timing andlevel parameters for the channelSwitch to the Channel PageSelect Pulse Mode DataSelect Pulse Type NRZSelect the ECL level formatIndicates that the Parametersare set for Channel 1You can switchbetween the two channelsby pressing this softkey1234 The LEDs show the statusof the outputsgray = disabled, green = enabled,crossed out = all outputs disconnectedEnable the Channel 1 normal Outputby pressing the respective softkey55Now let’s set the dataSwitch to the Data PageSwitch to the Numeric Edit ModeEnter a data patternlength of 32 bitsEnter your data pattern1423--

safety summary

setting up a data pattern

Keysight Technologies 81133A Getting Started Manual

81133A

Safety Summary

Before Applying Power

Initial Inspection

Power Requirements

Cleaning Recommendation

Declaration of Conformity

Benefits and Key Features

Front Panel Overview

Input and Outputs

Rear Panel Overview

Navigation through the

How to Navigate through the Parameters at one

How to Change a Number Field

Setting Up a Clock Signal

Using the Graphical User Interface

Keysight 81133A/81134A Pulse Generator User's Guide, April

Using the Remote Programming Interfaces

Setting Up a Pulse Signal

Setting Up a Data Pattern

Setting Up a Burst Signal

Setting Up a Repetitive Burst Signal

Measurement

Connecting the Instruments

Setting Up the 81134A by Using the Graphical User Interface

Setting Up the 33250A Waveform Generator

Play with the Settings

Using the Keysight 81133A/81134A Pulse Generator

Pages of the User Interface

Combining Parameters for Signal Generation

Pattern Modes

Signal Modes

Variable Crossover

Clock Sources

Start Mode

Timing of Generated Signals

Clock

Pulses

Data Pattern

PRBS

Started Burst

updating the firmware

troubleshooting

81134A