Keysight Technologies M9037A User Manual

Also see for M9037A: Startup guide Update guide

Contents

Keysight M9037A PXIe Embedded Controller User Guide 47Chassis and Controller Shutdown Using the ControllerWake on LANWake on LAN * (WoL, also known as Remote Wake-Up) is an industry standardprotocol for waking up computers that are in a low power mode (turned off butstill has power applied) to be turned on by a network message. Keysight’sM9037A supports WoL when the chassis and controller are powered down butAC power is still applied to the chassis.Both LAN ports are powered from the auxiliary power supply in the chassis even ifthe power is turned off (as long as AC power is still connected to the chassis).The chassis INHIBIT switch must be in the DEFault position.To configure the M9037A for WoL from power down:1 From the Windows10 right click on the Start button, select Device Manager >Network Adapters. From the WES 7 click on Start, select Control Panel > DeviceManager > Network Adapters.2 Double click on the Intel(R) Ethernet Connection I217-V. This opens theProperties dialog box for the Port #1 NIC. Note that Intel(R) I210 Gigabit NetworkConnection is for the LAN Port #2 NIC.3 Select the Power Management tab, then select both the Wake on Magic Packetfrom power off state and Wake on Link Settings check boxes.4 Click OK to save and exit the settings and then close the Windows DeviceManager.* The term “Wake on LAN” is a trademark of IBM Corporation.Figure 9 Set the Wake on LAN feature