Kiepe Elektrik HES Series Operating Instructions Manual
                              | |
Contents
| 
23Operating instructions HES and SEL5 Mounting and dismountingCONFIDENTIALd. Tighten the second screw (15) so that the cam(11) is fixed in the newly set position.5. Check the set switch points (see figure 5-9, page21).6. Check the gasket (22) of the cover (2) for damage.7. Close the cover (2) of the belt misalignment switch.8. Secure the cover (2) with the screws (5) (seefigure 5-12, page 23).Tighten the screws (5) evenly to a tighteningtorque of 1.5 Nm.9. Put the belt misalignment switch into operation (seesection 5.2.4: „Commissioning“, page 23).5.2.4 Commissioning1. Before putting the belt misalignment switch intooperation, ensure that it is sealed (see fig. 5-12):– Ensure that the screws (5) on the cover (2) aretightened with a tightening torque of 1.5 Nm.– Check that the screwed cable gland (6) istightened with a tightening torque of 6.7 Nm.– Check that the dummy plug (25) is fastenedtightly.2. Check the entire belt misalignment switch and itscomponents for damage.Beware!A device with a damaged gasket (22) must not be used.Remove any dust that may have entered the casing (1).! Danger!Always replace damaged belt misalignment switches.Fig. 5-12: Commissioning the belt misalignment switchScrew (5)Screw (5)Cover (2)Screwed cable gland (6)Dummy plug (25)! |
Related manuals for Kiepe Elektrik HES 21 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine