Kiepe Elektrik HES Series Operating Instructions Manual
                              | |
Contents
| 
26HES and SEL Operating instructions7 RepairsCONFIDENTIAL7 Repairs7.1 Replacing the roller lever1. Prior to working, switch off the power supply to thesystem. Ensure that the conveyor system cannot beaccidentally switched on. Mask any neighboringcomponents that may be live to prevent contact.2. Loosen the nuts (9) using a 16 mm open-endwrench and remove the roller lever (3) from the shaft(14) (see fig. 7-1).In order to minimize wear of the roller lever (3), mount theroller lever (3) in such a way that it is located approxi-mately 10 to 20 mm in front of the belt edge (see figure 5-2, page 16).3. Fit the new roller lever (3) onto the shaft (14).4. Set the roller lever (3) to the required position andtighten the self-locking nut (9) using an 16 mm open-end wrench.Danger of fatal electric shockWork on the device may be performed only by a quali-fied electrical technician.Prior to working, switch off the power supply to the sys-tem. Ensure that the system cannot be accidentallyswitched on. Mask any neighboring components thatmay be live to prevent contact.Beware!When tightening the nut (9), make sure the distance tothe cover (2) is sufficient enough so that the roller lever(3) will not come into contact with the cover (2) when theroller lever (3) is moving.!Fig. 7-1: Replacing the roller leverNut (9)The roller lever (3) must notcome into contact with thecover (2) when moving.Shaft (14) |
Related manuals for Kiepe Elektrik HES 21 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine