L-Acoustics WST K2 Rigging Manual

L-Acoustics WST K2 Rigging Manual Manual pdf 15 page image

K2_RM_EN_0.5 w w w . l - a c o u s t i c s . c o m 1 5 / 524.2 FlyingFinal checkAfter the setup, always verify no yellow labels are visible on the front and on both sides of the array.At least one motor for each K2-BARWhen using two K2-BAR, do not implement a bridle between the bars.Before setup, choose a flying optionRefer to SOUNDVISION modeling and to 3.3 Elements for flying (p. 2).K2 enclosures under K2-BUMP Prepare all the blocks of 4 K2 necessary to build the array.If a block is not already built, refer to PROCEDURE A. Preset the inter-enclosures angles.Refer to PROCEDURE B. Place an open a K2-BUMPFLIGHT under the motor. If necessary, attach one or two K2-BAR to the K2-BUMP.Refer to PROCEDURE D. If necessary, stack one or two LA-RAK on the K2-BUMP.Refer to PROCEDURE I.Refer to APPENDIX A: when stacking only one LA-RAK. Attach the shackles.Refer to SOUNDVISION for the number and position of the shackles. Lift the assembly so you can position a block of four K2 under it. Attach the block of four K2 to the K2-BUMPRefer to PROCEDURE E.Verify that the rear rigging arms are secured by pins and that no yellowlabel is visible on the front. Lift the assembly so you can position a block of four K2 under it.Verify that no yellow label is visible on both sides of the array. Attach the block of four K2 enclosures to the bottom of the array.Refer to PROCEDURE F.Verify that the rigging arms at the back are secured by pins and that noyellow label is visible on the front. Repeat the last two steps until the array is complete. Raise the array to its final trim height. Adjust site and azimuth angles.