L-Acoustics WST K2 Rigging Manual

L-Acoustics WST K2 Rigging Manual Manual pdf 16 page image

K2 WST® enclosureRIGGING MANUALVERSION 1.0K2_RM_EN_1.0 w w w . l - a c o u s t i c s . c o m 1 6 / 52Final checkAfter the setup, always verify no yellow labels are visible on the front and on both sides of the array.When using two K2-BAR, do not implement a bridle between the bars. Always use at least two motors. Referto APPENDIX A: PICKUP POINTS GUIDELINES.Before setup, choose a flying optionRefer to SOUNDVISION modeling and to 3.3 Elements for flying (p. 2).K2 enclosures under K1-SBK1-SB array setup Refer to your SOUNDVISION model to define which flying frame to use.If you are using the K1-BUMP: Refer to the K1 rigging manual to set up the K1-SB part of the array.Or if you are using the K2-BUMP: Place an open a K2-BUMPFLIGHT under the motor. If necessary, attach one or two K2-BAR to the K2-BUMP.Refer to PROCEDURE D. If necessary, stack one or two LA-RAK on the K2-BUMP.Refer to PROCEDURE I.Refer to APPENDIX A: when stacking only one LA-RAK. Attach the shackles. Refer to SOUNDVISION for the number and position of the shackles. Lift the assembly so you can position a block of K1-SB under it. Attach the K1-SB block to the K2-BUMP.Refer to PROCEDURE H. Repeat the last two steps until the K1-SB array is complete.K2 array setup Prepare all the blocks of 4 K2 necessary to build the arrayIf a block is not built already, refer to PROCEDURE A. Preset the inter-enclosures angles.Refer to PROCEDURE B.K1-SB and K2 arrays connection Lift the K1-SB array so you can position a block of four K2 under it. Using two K2-LINK interfaces, attach the block of K2 under the K1-SB array.Refer to PROCEDURE G.Verify that the rear rigging arms are secured by pins and that no yellow label isvisible on the front. Lift the array so you can position a block of four K2 under it.Verify that no yellow label is visible on both sides of the array. Attach the block of four K2 to the bottom enclosure of the array.Refer to PROCEDURE F.Verify that the rear rigging arms are secured by pins and that no yellow label isvisible on the front. Repeat the last two steps until the array is complete. Raise the array to its final trim height. Adjust site and azimuth angles.