Premier Ductable Heaterswww.lbwhite.comOwner’s Manual • Premier 35014CLAMPDUCT ADAPTERTABSDIFFUSERInstallation of HeaterInside of StructureFIG. 4Outside of Structure(Air distribution accessories -not supplied with heater)A. Flex Duct KitPart Number: 22835 (18 in. x 12 ft. / 46 cm x 3.65 m)1. Extend duct kit to 12 feet/3.6 meter length.2. Mount duct to blower outlet of heater by inserting tabson duct adapter into vertical and horizontal slots locatedat top and sides of blower outlet. See Fig. 5. Push downon duct adapter to secure adapter into slots. See belowfor typical installation of heater located at exterior.When using 12 ft. / 3.65m flex ducts, the maximumnumber of flex ducts to use per heater is 3. See Fig. 6for typical installation.FIG. 5SLOTSDUCT ADAPTERWITH TABSTABDUCT KITSIDE WALL500 GALLON (1892 litre)GAS SUPPLY(MINIMUM)MINIMUM SAFE DISTANCE FROMGAS SUPOPLY TO HEATER MUSTCONFORM TO LOCAL CODESDISTANCE FROM HEATER TO SIDE WALL MUSTCOMPLY WITH LOCAL CODES, AND BE ACCORDINGTO MANUFACTURER'S REQUIREMENTSMINIMUM SAFE DISTANCE FROMBLOWER OUTLET TO COMBUSTIBLESIS 6 FEET (1.83m)MINIMUM SAFE DISTANCE FROMTOP, SIDES, AND BACK OF HEATERTO COMBUSTIBLES IS 1 FOOT (0.3m)INSTALLATION INSTRUCTIONS FIG. 6MINIMUM SAFE DISTANCE FROM GASSUPPLY TO HEATER MUST CONFORMTO LOCAL CODESDISTANCE FROM HEATER TO SIDE WALL MUSTCOMPLY WITH LOCAL CODES, AND BE ACCORDINGTO MANUFACTURER'S REQUIREMENTSTENT DRAPED OVER DUCTDUCT KIT500 GALLON(1892 LITRE)GAS SUPPLY(MINIMUM)SIDE WALLTENT DRAPEDOVER DUCTB. End DiffuserPart Number: 231891. Loosen screw on duct clamp so clamp is easilypositioned over ribs at end of flexible duct.2. Slide duct adapter into duct end. Duct adapter tabsmust be facing away from duct and are located at 3,9 and 12 o’clock positions. See Fig. 7.3. Tighten screw clamp so adapter is held securely-within duct.4. Insert tabs of adapter into slots on air diffuser back.5. Push down on adapter so tabs are seated firmly toair diffuser.6. Locate diffuser under side wall. See Fig. 8.FIG. 7