La Castellana GIANGI CC Service Manual And Maintenance
                                                                                                                                        | |
Contents
| 
Manuale d’istruzione Sez.7 All. 9 Rev. 3 del 25.07.2013 33CLEANING AND MAINTENANCECleaning and maintenance made by Customer before each cold ignitionby using an aspirator:• Open the cover and draw the fire surface.• Remove the crucible, verify the cleanliness and clean the slots too.• Aspirate the chamber compartment, clean the edges of contact, replace thecrucible.• Drain the ash pan, if present.• Clean the glass with a wet or dry cloth ( always when stove is cold). It is possibleto use the ash to clean the glass by combustion residues.Note: while replacing the crucible, please make sure that its edges fully adhere to theirlocation and that the hole matches with the resistance pipe: there must be no residuein the combustion zone of contact between the edges of the crucible and the cruciblesupport surface. Close the cover and the ash pan.PERIODICAL MAINTENANCE MADE BY SERVICE CENTEREvery 6 months:• General cleaning of inner and outer flue of the stove• Removal of the inner lining of the firebox, thorough cleaning and descaling ofcrucible and corresponding compartment.• Clean fan and mechanically inspect plays and fastenings.• Clean, inspect and descale ignition resistance and its compartment.• Clean the front panel keypad and the remote control.• Visual inspection of electrical wiring, connections and power cable.• Clean pellet hopper and check auger with cochlea- auger motor.• Functional test, screw feeding loading, ignition.Every 12 months:In addition to all transactions foreseen every 6 months:- Replace cartridge power ( if used daily with over 3 ignitions per day)- Inspect and clean the smoke duct.- Inspect and check the chimney flue draft ( possibly perform or requirecleaning) |
manualsdatabase
Your AI-powered manual search engine