La Gard 3000 Installation Instructions Manual
Also see for 8130: Installation instructionsManualInstallation instructionsUser operating instructions
             | |
(P/N)762.128 Rev E • 08/15 © copyright 2009-2015 Kaba Mas LLCpage 7The 3710 Entry Device comes with the mylar portion of the keypad unattached.1. Feed the key pad cable through the spindle cable hole from the front of the safe door. (Figure 5).2. Position the Entry Device over the screw holes on the door, and lift the keypad to expose themounting holes.3. Install the two #8-32 screws (US) or the M4-0.7 screws (metric) to mount the Entry Device tothe door.NOTE: Ensure that the battery connector is routed through the battery open at the bottom of thehousing, and no wires are pinched under the housing.4. Remove the adhesive strip from the back of the keypad and carefully align before adhering tothe housing (Figure 6). Prior to adhering, make sure that the housing is completely free of debrissuch as filings, dust, etc., for the best possible contact.WARNING: Once installed, the Entry Device cannot be removed from the safe door without causingphysical damage to the keypad.5. Ensure that the Entry Device cable is running through the channel at the back of the lock. Refer to lockinstallation instructions which are available at www.kaba-mas.com.ALTERNATE INSTALLATIONThe option adapter plate (p/n 3716) may be used to mount the 3710 Entry Device to a safe withvertical mounting hole (12 and 6 o’clock).1. Mount the adapter plate centered on the through hole. Attach the dialplate with the two mounting screws US 8-32 (US) or the M4-0.7 (metric).Then follow the above installation instructions.NOTE: To maintain A2P/EN1300 Agency Certification, tamper evident seals must be placed on entry.Please refer to document P/N 7025.0514 for more information.BATTERY INSTALLATION1. If installed, remove black plastic battery compartment cover (located at the bottom of the keypad) bygently pulling downward on its handle.2. Allow the battery connector and its attached leads to drop down and out of the batterycompartment. If it does not drop, gently pull on the battery connector until it does.CAUTION! Hold onto battery terminal connector to avoid pulling the wires out of housing.3. Connect a new 9-Volt alkaline battery to the battery connector.4. Push the battery and the leads completely into the battery compartment.5. Install the battery cover by placing one side of the cover in position and then pressing theother side into position with your finger.3716Figure 5Figure 637103710 ANGULAR ENTRY DEVICE (ADDITIONAL INSTRUCTIONS 3716 ADAPTER) |
manualsdatabase
Your AI-powered manual search engine