Dolby Lake Controller User Manual PLM Edition Addendum 19amp output current▸ – Shows the PLM channel’soutput current relative to its maximum safe value.(This is the value at which the CPL becomesactive.)amp output voltage▸ – Shows the poweroutput channel’s voltage relative to the voltagepermissible, regardless of ISVPL setting.amp output power▸ – Shows the power outputchannel’s power relative to the maximum ratedpower.Total output power▸ - Shows the total outputpower (sum of all channels in that Frame) relativeto the maximum rated power.5.5.2 peak/averageThe peak and average buttons in the selectdimension box determine whether the datadisplayed on the graph is the log of peak values for theparameter being displayed, or an average value.If peak is selected, the curves displayed will be ofthe highest values attained by each parameter withinthe two minute sample period.If average is selected, the curves will be of pointsrepresenting the average of the values measuredduring the sample period.5.5.3 ChannelsThe graph can display data for any power outputchannel which is assigned to the currently selectedModule, or any combination of channels. The numberof channel buttons which appear in the selectchannel(s) box will depend on how the Module isconfigured. The Channel buttons are labeled with thenames allocated to them by the configuration whichhas been loaded into the Module. The curves on thegraph are color coded, with a key color shown beloweach channel button.The select/Deselect all button toggles states toeither select or deselect all channels on the selectedmodule.When only one channel is selected, clickingon the graph will display the time and samplenumber for that particular sample on thestatus line.A white dot is displayed on the graphs if apowercycle of the frame was performedduring the sampling period.operation 5