Lackmond BEAST5 Instruction Manual
                                          | |
7UNPACKINGB1 B2 B3B4B5B6 B7 H1 H2ASSEMBLYATTACH THE BLADE FENCE1. Install the wear-plate wedge clips (H2) asshown in Figure 5.2. Attach the wing screws (H1) but do nottighten.3. Carefully insert the blade fence (8, B5) so thatthe ends of the fence arms slide under thewedge clips.NOTE: The blade fence may be inserted andused upside down or right side up.When used right side up, the bottom lip of thefence is lower than the bottom plate of the saw,enabling you to use the edge of your workpieceas a guide.When installed upside down, the bottom of thefence is level with the bottom plate of the saw,keeping the bottom plate level to the workpiecewhile letting you use any perpendicular surfaceas a guide.4. Tighten the wing screws but do notovertighten.FIGURE 5H2H1B5NOTE: The part and hardware names and numbers correspond to those used in Saw Features on page 6and the Shipping Contents on page 7.SHIPPING CONTENTSIn the BoxDescription (QTY)B1. Beast5 handheld wet/dry tile saw (1)B2. 5-inch blade (1)B3. Blade wrench (1)B4. T-wrench (1)NOTE:B5. Blade FenceB6. ¼-inch hose with standard hoseconnection (1)B7. 20mm to 5/8-inch bore adapter (1)In the Hardware BagH1. M6 Wing screws (2)H2. Wear-plate wedge clips (2)7 |
Related manuals for Lackmond BEAST5
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine