Lamona LAM1006 User Manual

Contents

Lamona LAM1006 User Manual Manual pdf 17 page image

17_LAMONA AppliancesGas Connection,lennosrepdeifilauqroferasnoitcurtsniesehTinstallation of equipment must be in line withrelevant national standard. (For U.K only: bylaw the gas installation\commissing must becarried out by a “Gas Safe” installer).All work must be carried out with the electricitysupply disconnected.The rating plate on the hob shows the typeof gas with which is it designed to be used.Connection to the mains gas supply or gascylinder should be carried out after havingchecked that is regulated for the type of gas withwhich it is supplied. If it is not correctly regulatedsee the instructions in the follwoing paragraphsto change gas setting.For liquid gas (cylinder gas) use pressureregulators which comply with the relevantnational standards.Use only pipes, washers and sealing washerswhich comply with relevant national standards.For some models a conic link is furnishederehwseirtnuocehtninoitallatsniehtrofthis type of this link is obligatory: in the imagebelow it is pointed out how to recognise thedifferent links (CY= cylindrical, CO= conic). Inevery case the cylindrical part of the link has tobe connected to the hob.When connecting the hob to the gas supply viause semi-rigid hoses please ensure that themaximum distance covered by the hose doesnot exceed two metres.CylindricalConicalAdapting the hob to differenttypes of gasTo adapt the Hob for use with different types of gas,carry out the following instructions:• Remove the grids and burners• Insert on hexagonal spanner (7mm) into theburner supportUnscrew the injector and replace it with onesuitable for the gas to be used (see gas type table)To adapt the Hob for use with different types of gas,carry out the following instructions:• Remove the grids and burners• Insert on hexagonal spanner (7mm) into theburner support• Unscrew the injector and replace it with onesuitable for the gas to be used (see gas typetable)To replace the injectors ‘B’ with injectors of a sizecorresponding to the type of gas to be used, see thetable on P20.BNOTICEIf the gas type of the unit is changed, then the ratingplate that shows the gas type of the unit must alsobe changed.