Lampo IP65 LED User Manual
Also see for IP65: User manualUser manualUser manual
                    | |
2Dimensions & weight= 1,9 KgTechnical data- IP65 protection rate- Aluminium body with silicone gasket- Ideal for out-door, can be installed in any position- Input voltage range: from 85Vac to 265Vac. Frequency: 50-60 Hz- 0,95 PFC electronically controlled- Can drive up to 36LEDs (RGB) or 48 LEDs (RGB+W or RGB+A) at 350mA- On request it is possible to use 700mA controlled current- 4 independent LEDs groups: 12 Red, 12 Green, 12 Blue and 12 White or Amber- Electronic board 8/16 bit resolution with 4 digit display- Works via signal DMX, works in stand alone mode (Master/Slave)- On request it is possible to use infra-red remote control (with pre-programmed sequences)ATTENTION!!!LED POWER RGB is designed to drive:- Max 36 LEDs (1.2W 350mA) RGB- Max 48 LEDs (1.2W 350mA) RGB+W o RGB+A- Max 36 LEDs (1.2W 350mA) White on 3 channel- Max 48 LEDs (1.2W 350mA) White on 4 channelStorageThe power supply, in its original packing, must be kept in covered, dry areas with a temperature between –10°C and +50°C.Attention, the projector will be damaged during the unpacking.Admissible environmental conditionsThe power supply was engineered and produced to function in out-door areas with an air temperature ranging between -20°and +30°C and with a humidity level between 30 and 90%.When choosing the installation, please make sure that the device is not exposed to extreme heat or in small area. |
Related manuals for Lampo IP65
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine