406 Commissioning6.4.4 Setting Monitoring Parameters6.4.4.1 Automatic settingThis section describes the learning processes for setting the monitoring parameters.WARNING!Checking the switch-off parametersThere is a risk of death and serious injury. The preset switch-off parameters are to be verified through switch-off tests seeSection 6.4.5 Switch-off TestRecording the signal with the flame ON You must have aligned the device and set the amplification to optimum effect beforehand. Select the firing-rate state with the lowest signal amplitude. This is normally the base fir-ing-rate.NOTICE You can open the menus Record flame ON, Record flame OFF and Analyse individuallyor process them as a series. You can also have the monitoring parameters set automatically and/or set them manually. You can switch to the next menu in the sequence or select the next step "freehand".1. Open the Automatic flame ON/OFF parameter setting > Record flame ONmenu.Fig. 6-10 "Record flame ON" display2. Start the automatic recording of the "Flame ON" parameters by pressing .Fig. 6-11 The "flame ON" flame data is recorded
