PremierWave® EN Embedded System on Module User Guide 12013: Management Interface SettingsCommand Line Interface SettingsThe Command Line Interface settings allow you to control how users connect to and interact withthe command line of the PremierWave EN embedded system on module. It is possible to configureaccess via the Telnet and SSH protocols, in addition to general CLI options.Basic CLI SettingsThe basic CLI settings control general CLI access and usability options.Table 13-1 CLI Configuration SettingsTo View and Configure Basic CLI SettingsUsing Web Manager To view CLI statistics, click CLI in the menu and select Statistics. To configure basic CLI settings, click CLI in the menu and select Configuration.Using the CLI To enter CLI command level: enable -> config -> cliUsing XML Include in your file: name=”cli”>Command Line InterfaceConfiguration SettingsDescriptionLogin Password Enter the password for the admin account. “PASS” is the default password.Enable Level Password Enter the password for access to the Command Mode Enable level. There isno password by default.Quit Connect Line Enter the Quit Connect Line string to be used to terminate a Telnet and SSHsession and resume the CLI. Type before the key to be pressedwhile holding down the [Ctrl] key (example: L)Inactivity Timeout Set a time period in which the CLI session should disconnect if no data isreceived. Enter 0 to disable. Blank the display field to restore the default.Line Authentication Select to enable or disable authentication for CLI access on the serial lines.
