214Configuration: SettingsMenu: SETTING / TemperatureCommand: TdSetting the thermal energy for the heated roller for lamination. The correcttemperature must be experimentally determined with consideration to thelamination speed, the film and the plastic card. The presetting must be considereda guideline value.Setting range(d): 120...150...180 degree CMenu: SETTING / Lamination SpeedCommand: GdSetting of the transport speed of the document during lamination. The correctspeed must be experimentally determined with consideration to the laminationtemperature, the laminate film and the plastic card. The presetting must beconsidered a guideline value.In order to carry out a test it is possible to start the motor viaSetting range(d): 4...6...20 mm/sMenu: SETTING / Delay HeatrollerCommand: DdSetting the waiting time, once the heated roller has lowered and lies on thedocument. Only after this time does the actual lamination start.Setting range(d): 0...200...2000 msMenu: SETTING / Transport SpeedCommand: HdSetting the transport speed of the plastic card outside of lamination. In order tocarry out a test it is possible to start the motor via .Setting range(d): 40...60...80 mm/s
