Lapis Lamina006 User Manual
                                          | |
Contents
| 
367After starting the Windows application BootControl it is possible to load newfirmware. Prior to this the interface agreements as well as the path for the accessto the application code (*.HEX) must be stipulatedThe download process normally can be started as follows:• Switch on laminator• Press „Starting firmware update“If anything goes wrong and the update-process cannot started, you need theservice-panel and started as follows:• Switch on laminator and simultaneously hold the key down• Press „Starting firmware update“For service purposes the laminator is connected with the computer via the serialinterface. A standard cable RS-232 SERIAL SUB D9 connector jack is used.Alternative, you also can use the LamiControl-Tool for downloading the newestfirmware and programming.Windows-Application: BootControlF1 |
Related manuals for Lapis Lamina006
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine