Laversab 6600 User Manual
                                                                               | |
Contents
| 
453.5.4 FUNCTION 4: VIEW & EXECUTE PROFILESTo execute a profile, press Function Select and then press “4”. This will bring you back intothe Main Screen as shown below. You will need to enter the profile number that you want toexecute. A full explanation of profiles is given in Section 4.Units: knots Feet/min FeetActual: M 101.2 3500 1005 MTarget: 20.0 3000 0ENTER PROFILE NUMBER : .Profiles may be executed from both 2-output and 3-output formats. During the execution of aprofile, it is possible to toggle between the two formats using the PREV SCREEN key.Assuming you enter a profile number of “2.1”, followed by the ENTER key, the first point ofprofile # 2 will be displayed on the screen. Also, the name of the profile is shown here. This isshown in the screen below. The name of profile 2 is CJ1-RVSM. In this profile note that bothModes changed to “C”, and all three target values changed. These parameters wereprogrammed as the first point of profile # 2. You will also notice that the number “2.1” isflashing. This indicates that the current profile point is ready for execution and awaiting the“GO” key to be pressed. When the “GO” key is pressed, the 6600 will execute the profilepoint, i.e. it will change to Control mode and move towards the desired targets.Units: knots Feet/min FeetActual: C 101.2 3500 1005 CTarget: 100.0 5000 1000ENTER PROFILE NUMBER : 2.1 CJ1-RVSMOnce the targets have been achieved, you can move to the next profile point by pressingENTER. Then, the parameter values in point 2 of profile # 2 will be displayed, the profilenumber will change to “2.2” and will again flash, awaiting the “GO” key.If you want only to view the profile without executing it, then DO NOT press the “GO” key.Simply press the “ENTER” key to go to the next point in the profile. Each time you press the“ENTER” key, the next profile point will be displayed. When you press the “ENTER” keyafter the last point in the profile, the Main screen will revert back to its original setting prior toinvoking Function 4.At any time, to exit out of the profile viewing or execution function, press CANCEL and thescreen will revert back to the last executed point and line 4 will be cleared. |
Related manuals for Laversab 6600
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine