824.9.4 Activate Patrol (tour)In X 3 4 1 H 3 4 1 H 3 4 1 H Figure 4-40, input patrol (tour) number in the No. blank and click patrol button4.9.5 Pattern SetupIn Figure 4-40, click pattern button and then click “begin” button. The interface is shown as inFigure 4-44. Then you can go to Figure 4-37 X to modify zoom, focus, and iris.Go back to Figure 4-44 and click “end” button. You can memorize all these operations as pattern1.Figure 4-444.9.6 Activate Pattern FunctionIn X 3 4 6 H 3 4 6 H 3 4 6 H Figure 4-39, input mode value in the No. blank, and click pattern button.4.9.7 Auto Scan SetupIn X 3 4 7 H 3 4 7 H 3 4 7 H Figure 4-38, click border button. The interface is shown as in X 3 4 8 H 3 4 8 H 3 4 8 H Figure 4-43.Please go to X 3 4 9 H 3 4 9 H 3 4 9 H X 3 4 9 H 3 4 9 H 3 4 9 H Figure 4-35, use direction arrows to select camera left limitThen please go to X 3 5 0 H 3 5 0 H 3 5 0 H Figure 4-43X and click left limit buttonRepeat the above procedures to set right limit.Figure 4-454.9.8 Activate Auto ScanIn Figure 4-41, click “Auto Scan” button, the system begins auto scan. Correspondingly, the autoscan button becomes Stop button. Click stop button to terminate scan operation.4.11 FlipIn Figure 4-41, click page switch button, you can see an interface is shown as below. See Figure4-46. Here you can set auxiliary function. The aux value has relation ship with the Aux button ofthe decoder.Click page switch button again, system goes back to Figure 4-37.
