214367 5 Revision A2 Unloading the HeaderCAUTIONTo avoid injury to bystanders from being struck by machinery, do NOT allow people to stand inunloading area.CAUTIONEquipment used for unloading must meet or exceed the requirements specified below. Using inadequateequipment may result in chain breakage, vehicle tipping, or machine damage.1013855ABCFigure 2.1: Minimum Lifting CapacityA - Load Center of GravityB - Load Center 1220 mm (48 in.) from Back of ForksC - Minimum Fork Length 1981 mm (78 in.)IMPORTANT:Forklifts are normally rated for a load located 610 mm(24 in.) ahead of the back end of the forks. To obtain theforklift capacity at 1220 mm (48 in.), check with your forkliftdistributor.Table 2.1 Lifting VehicleMinimum Capacity 3630 kg (8000 lb.)Minimum Fork Length 198 cm (78 in.)1009203Figure 2.2: Lifting Header off Trailer1. Remove hauler’s tie-down straps and chains.WARNINGBe sure forks are secure before moving away from load.Stand clear when lifting.2. Approach header from its underside and slide forks inunder the lifting framework as far as possible.IMPORTANT:If load is two units wide, take care to avoid contactingthe other machine.3. Raise header off the deck.
