Magellan MobileMapper MobileMapper 6 Getting Started Manual

Contents

English6connected, the built-in antenna is automaticallydisconnected from the receiver input.Side View (Right) Power ButtonUse the Power button [16] to turn the MobileMapper 6 On orOff.A short press of the Power button will put the receiver insuspend mode. This means that when you next turn it on, thereceiver will restore the context in which it was when you lastturned it off.A long press on the Power button (about 5 seconds), removalof the internal battery, disconnection of the external ACadapter or a reset action will completely shut down thereceiver.SD Card SlotGives access to a slot [17]* where you can insert or extract anSD card.Earphone OutputA 1/4-inch jack (TRS connector) [18]* is used to connect anearphone to the MobileMapper 6.Top ViewThree-LED FlashlightThis is a powerful flashlight [19] that can advantageously beused in dim light conditions. Using MobileMapper 6 as aflashlight may however be incompatible with GPS reception,i.e. in the way you hold the receiver.Reset buttonPress the Reset button [20] using the stylus when you needto perform a software reset. This will re-boot the WindowsMobile Operating System.Rubber FlapsItems [14], [15], [17] and [18] presented above are allmarked with a “*” symbol indicating that a black rubber flapis used to protect each of them.To access one of these items, just insert the stylus behind theflap and pull it open.[16][17][18][20][19]