12PREPARATIONNo supplied cables are used with these connections:• Please purchase the necessary cables at your local store.Before you connect:Be sure your antenna or other device is connected properlybefore plugging in the AC power cord.Antenna ConnectionConnect the RF coaxial cable on your home outlet to theantenna input jack of this unit.VHF / UHFVHF / UHFanaloganalogororDTV antennaDTV antennacable TV signalcable TV signalorRF coaxial cableRF coaxial cableOnce connections are completed, turn on the unit and begininitial setup. Channel scanning is necessary for the unit tomemorize all available channels in your area. [Initial Setup]➠ p.13Note• If you have any question about the DTV’s antenna, visitwww.antennaweb.org for further information.• Depending on your antenna system, you may need different typesof combiners (mixers) or separators (splitters) for HD TV signalthe minimum RF bandpass on these devices is 2,000MHz or 2GHz.• For your safety and to avoid damage to this unit, please unplug theRF coaxial cable from the antenna input jack before moving theunit.• If you did use an antenna to receive analog TV, it should alsowork for DTV reception. Outdoor or attic antennas will be moreeffective than a set top or inside antenna.• To switch your reception source easily between antenna and cable,install an antenna selector.• If you are not receiving a signal from your cable service, contact theCable provider.Connection to Cable Receiver orSatellite BoxUse an HDMI or Component Video cables to connect theHDMI or the Component Video Input jacks of the unit to theHDMI or the Component Video output jacks of the cablereceiver / satellite box.If you connect to the unit’s Component Video Input jacks,connect Analog Audio cables to the Analog Audio L/R Inputjacks for the Component Video connector jacks.STEREOPCMCOMPONENT VIDEO OUTPr/CrPb/CbYAUDIO OUTRLANT INHDMI OUT(red)(red)(blue)(blue)(green)(green)cable receiver /cable receiver /satellite boxsatellite boxcable TV signalcable TV signalincluding PPVincluding PPVcomponent video cablescomponent video cables(red / blue / green) and audio cables(red / blue / green) and audio cablesRF coaxial cableRF coaxial cableororororHDMIHDMIcablecablesatellite dishsatellite dishYou can also connect this unit to the cable receiver or satellitebox other than the HDMI or the Component Video output jacksor Composite Video output jack (➠ p.35) because they mighthave different output jacks.Required cables and connecting methods of the cable receiver /satellite box, or the availability channel for the clear QAMmay differ depending on the cable / satellite provider or localTV broadcaster. For more information, please contact yourcable / satellite provider or local TV broadcaster.Note• Use an HDMI cable with the HDMI logo (a certified HDMI cable).High Speed HDMI cable is recommended for the bettercompatibility.Plug In the AC Power CordMake sure that the AC power cord must be plugged to an ACoutlet after all the necessary connections are made.Caution:• Do not connect the AC power cord to a power supply outsidethe indicated voltage of this unit (AC 120V).Connecting the AC power cord to a power supply outside of thisrange may result in fire or electrical shocks.Note• Each time you plug in the AC power cord, no operations will beperformed for a few seconds. This is not a malfunction.