Magnavox MBP5120F Owner's Manual

Also see for MBP5120/F7: Quick start guide Specifications

36Network Connection[SETUP]B B“Others“B“Network Connection”Set up network connection settings in order touse BD-Live, VUDU or network update function.Connection TestAfter you enable a network connection orchange the network settings, always performthe connection test to check if the connection iscorrectly made.1. In “Network Connection” menu, use [K/L] toselect “Connection Test”, then press [OK].Connection test will start automatically andthe test result will appear right after theconnection test finishes.• “Testing...” : The test is in progress.• “Pass” : Connection test is successfullycompleted.• “Fail” : Connection test failed. Check theconnection settings.If the connection test passes, press [OK].• Confirmation screen of the network selectionwill appear.e.g.) Wired connectionOthersNetwork Selectionthen press ‘OK’ .WiredConnection TestPress [OK] again to display the confirmationscreen of network settings.OthersIP AddressSubnet MaskDefault GatewayPrimary DNSSecondary DNSthen press ‘OK’ .xxx.xxx.xxx.xxxxxx.xxx.xxx.xxxxxx.xxx.xxx.xxxxxx.xxx.xxx.xxxxxx.xxx.xxx.xxxConnection Test2. Press [OK] to go back to the previous screen,or press [SETUP] to exit.Note• If the connection test passes, you are readyto use BD-Live, VUDU or network updatefunction using the Internet without making anyadditional settings.• If the connection test fails, you may need tochange the MAC address settings on yourrouter. You can check the MAC address of thisunit on “Custom” screen. (Refer to “Custom(Wired)“ on page 36.)• When connecting this unit directly to a modemfor the first time or connecting it to a modemwhich was previously connected to any othernetwork device(e.g. a router, PC, etc.), you mayhave to power cycle the modem to reset thesettings on the modem.• “Connection Test” is not available when“Disable” is selected in “Network Connection”.Network Selection WiredSelect “Wired” if you made a wired connection andset the setting to “Easy”(wired) or “Custom”(wired),in accordance with your network environment.Network settings are set to the following settingsinitially. (In most cases, you can connect to theInternet without making any changes to thedefault settings.)- IP Address Setting Auto(DHCP)- DNS Setting Auto(DHCP)- Proxy Setting Do Not Use- Connection Speed Auto- BD-Live Setting AllowIf you want to set the network settings back tothe default settings as above (except “BD-LiveSetting”), follow the procedure below.1. In “Network Connection” menu, use [K/L] toselect “Network Selection”, then press [OK].2. Use [K/L] to select “Wired”, then press [OK].3. Use [K/L] to select “Easy”, then press [OK].• The unit will start the connection testautomatically and the test result will appearright after the test finishes.4. Press [OK] to activate the networksettings and set the network connectionautomatically. Press [SETUP] to exit.Note• The setting of “BD-Live Setting” will not beset back to the default, even if you follow theprocedure.In following cases, select “Custom”(wired) to seteach setting as necessary.- When connection test failed with the settingof “Easy”(wired).- When instructed by your Internet serviceprovider to make specific settings inaccordance with your network environment.To set the network setting to “Custom”(wired),follow the following procedure.