Magnetek inteleSmart2 Manual

Magnetek inteleSmart2 Manual Manual pdf 26 page image

inteleSmart2 Instruction ManualJune 2016Page 26 of 497. PROGRAMMING WITH RCPUsing the optional RCP software makes programming of the inteleSmart2 easier and allows for settingsto be saved for future reference.WARNINGTHE USE OF RCP (RADIO CONTROL PROGRAMMER) IS INTENDED FOR USE BY AUTHORIZED PERSONSONLY. CHANGES TO ANY RADIO DATA VALUE MAY LEAD TO UNEXPECTED, UNDESIRABLE, OR UNSAFEOPERATION OF EQUIPMENT AND FURTHERMORE MAY LEAD TO EQUIPMENT DAMAGE, PERSONALINJURY, OR EVEN DEATH. ALL EQUIPMENT OPERATORS AND/OR PERSONNEL SHOULD BE NOTIFIED OFANY RADIO DATA VALUE CHANGES THAT MAY AFFECT OPERATION.7.1 ACCESS CODESThe receiver and transmitter must be programmed with the same access code to properly communicatewith each other.WARNINGTWO OPERATIONAL TRANSMITTERS WITH THE SAME ACCESS CODES OPERATING AT THE SAME TIME ISA DEFINITE SAFETY HAZARD – DO NOT OPERATE THEM AT THE SAME TIME. FAILURE TO FOLLOW THISWARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.7.2 CHANGING ACCESS CODESTransmitter Access Code Programming. For detailed instructions on setting parameters, includingaccess codes, see the “Programming” section of the applicable transmitter manual.WARNINGAFTER CHANGING THE ACCESS CODES ON THE TRANSMITTER, TEST THE UNIT BY TURNING IT ON ANDOFF NEAR THE APPROPRIATE RECEIVER. IF THE RECEIVER DOES NOT RESPOND, DO NOT ACTIVATE AFUNCTION BUTTON! THE TRANSMITTER MAY HAVE THE WRONG ACCESS CODE, WHICH COULD MOVEOTHER EQUIPMENT. RE-CHECK THE ACCESS CODE IN THE TRANSMITTER AND RETEST. FAILURE TOFOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO EQUIPMENT.