Makita 2012NB Instruction Manual

Also see for 2012NB: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

6• Clean out all chips, dust, pitch or foreign matteradhering to the drum or blades before installing theblades.• Use blades of the same dimensions and weight , ordrum oscillation/vibration will result, causing poorcutting action and eventually, tool breakdown.• Replace both blades at the same time.• The disposable-type blade has a cutting edge onboth sides. When one cutting edge becomes dull,you can use the other cutting edge. Always removeresin and dirt sticking to the reverse side of theblade before using the other cutting edge. Thisblade must not be re-sharpened. When both cuttingedges become dull, the blade should be carefullythrown away.1. Removing bladesLoosen the thumb screw which secures the chip coverand remove the chip cover. Remove the screws whichsecure the right side cover. Then remove the right sidecover. Turn the pulley until the drum can be locked in theposition whereby the blade installation bolts face upward.41 2 3003715For throw away blades onlyPlace the two magnetic holders on the set plate and pushthem in the direction of the arrow until the claw contactthe blade. Remove the six blade installation bolts usingthe socket wrench. Grip the magnetic holders and raisethem straight up to remove the set plate and the bladefrom the drum. Press the lock plate and turn the pulley180° to lock the drum. Remove the other blade asdescribed above.12345 600371612003717For standard blades onlyRemove the six installation bolts using the socket wrench.Raise the set plate and blade straight up to remove themfrom the drum. Press the lock plate and rotate the drumby turning the pulley 180° to lock the drum. Remove theother blade as described above. Remove the set platefrom the blade.12300446810044691. Installing bladesCAUTION:• Use only Makita socket wrench provided to tightenthe blade installation bolts. The use of any othersocket wrench may cause overtightening orinsufficient tightening of the bolts, resulting insevere injury.For throw away blades onlyProvide a flat wood block approximately 300 mm longand 100 mm wide. Place the blade and the set plate onthe wood block so that the blade locating lug of the setplate rests in the groove of the blade. Adjust the set plateso that both ends of the blade protrude approximately 1mm beyond the end of the set plate. Place the twomagnetic holders on the set plate and push them until theclaw contacts the blade.1. Set plate1. Socket wrench2. Lock plate3. Blade installationbolt1. Socket wrench2. Magneticholders1. Blade installationbolts2. Set plate3. Magnetic holder4. Drum5. Blade6. Claw1. Lock plate2. Drum3. Thumb screw4. Pulley

/ 12

Related manuals for Makita 2012NB

Makita 2012NB Instruction Manual

Makita 2012NB/2 Instruction Manual

This manual is suitable for:

2012NB

manualsdatabase

Your AI-powered manual search engine