Makita 2012NB Instruction Manual

Also see for 2012NB: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

10Changing type of bladeThis tool can accept either throw away blades or standard blades. If you wish to change the type of blade, buy and usethe following parts.Hood set (Fig. 17)When you wish to maintain clean operations through easy dust collection, connect the vacuum cleaner to the thick-nesser using this hood.Loosen the thumb screws which secure the chip cover. Attach the hood to the thicknesser and secure the chip coverand the hood together by tightening the thumb screws.CAUTION:• When installing the hood set, make sure that the chain is not caught by the chip cover or hood set. (Fig. 18)Stand (optional accessory)Place the stays on a level location and assemble the legs inside. Secure with the cap square neck bolts, spring wash-ers and hex nuts, then attach the rubber caps to the ends of the legs.Now set the thicknesser on the top of the assembled stand and secure with the four hex bolts, flat washers and hexnuts. (Fig. 19)NOTE:• Insert the hex bolts through the holes from the reverse side of the stand and secure them with the flat washers andhex nuts. If you insert the hex bolts from above the thicknesser base, the hex bolts cannot be firmly secured.(Fig. 20)The stand should be bolted with the four bolts to the floor using the bolt holes provided in the legs. (Fig. 21)OPERATIONCAUTION:• Two or more pieces of narrow but similar thickness stock can be passed through the thicknesser side by side. How-ever, allow some spacing between the stock to permit the feed rollers to grip the thinnest piece of stock. Otherwise, aslightly thinner piece could be kicked back by the cutterhead.Place the workpiece flat on the table top.Determine the depth of cut as described before.Switch on the tool and wait until the blades attain full speed. The workpiece should not be in contact with the feed rollerwhen you turn the tool on.Then insert the workpiece flush with the table top.When cutting a long or heavy workpiece, lift up its end slightly at the start and the end of the cut to avoid gouging orsnipping at the extreme ends of the workpiece.The use of the tool top enables quick, effortless return of the workpiece to the infeed table side. This is especially con-venient with two operators. (Fig. 22)Changing from standard blade to throw-away blade Changing from throw-away blade to standard bladeSet plate 2 pcs. Set plate 2 pcs.Throw-away blade (306 mm) 2 pcs. Pan head screw M 4 x 6 4 pcs.Magnetic holder 2 pcs. Standard blade 2 pcs.Blade gauge 1 pc.