Makita 4303C Instruction Manual

VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,outlet, etc.) be sure the voltage supplied is the same as that specified on thenameplate of the tool. A power source with voltage greater than that specifiedfor the tool can result in SERIOUS INJURY to the user - as well as damage tothe tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source withvoltage less than .the nameplate rating is harmful to the motor.ADDITIONAL SAFETY RULES1. Avoid cutting nails. Inspect for and remove all nails from the workpiece be-2. Don't cut hollow pipe.3. Do not cut oversize workpiece.4. Check for the proper clearance beneath the workpiece before cutting so that5. Hold the tool firmly.6. Make sure the blade is not contacting the workpiece before the switch is7. Keep hands away from moving parts.8. When cutting through walls, floors or wherever "live" electrical wires maybe encountered, DO NOT TOUCH ANY METAL PARTS OF THE TOOL!Hold the tool only by the insulated grasping surfaces to prevent electric shockif you cut through a "live" wire.fore operation.the blade will not strike the floor, workbench, etc.turned on.9. Do not leave the tool running. Operate the tool only when hand-held.IO. Always switch off and wait for the blade to come to a complete stop before11. Do not touch the blade or the workpiece immediately after operation; theyremoving the blade from the workpiece.may be extremely hot and could burn your skin.SAVE THESE INSTRUCTIONS.4