Makita AN923 Instruction Manual

Also see for AN923: Instruction manual Instruction manual Parts Breakdown Instruction manual Instruction manual

Contents

Makita AN923 Instruction Manual Manual pdf 2 page image

2ENGLISH (Original instructions)SPECIFICATIONSModel AN923 AN943Air pressure 4.5 - 8.5 kgf/cm 2G (65 - 120 PSIG)Nail length 50 mm (2") - 90 mm (3-1/2")Nail capacity 64 - 74 pcs. 60 - 84 pcs.Min. hose diameter 8.5 mm (5/16")Dimensions (L X H X W) 559 mm X 347 mm X 109 mm(22" X 13-11/16" X 4-1/4")455 mm X 365 mm X 109 mm(17-7/8" X 14-3/8" X 4-1/4")Net weight 4.0 kg (8.7 lbs)• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003.USB086-2IMPORTANT SAFETYINSTRUCTIONSWARNING: WHEN USING THIS TOOL, BASICSAFETY PRECAUTIONS SHOULD ALWAYS BEFOLLOWED TO REDUCE THE RISK OF PERSONALINJURY, INCLUDING THE FOLLOWING:READ ALL INSTRUCTIONS.1. For personal safety and proper operation andmaintenance of the tool, read this instructionmanual carefully before using the tool.2. Always wear safety glasses to protect youreyes from dust or nail injury. The safetyglasses should conform with the requirementsof ANSI Z87.1.WARNING:It is an employer's responsibility to enforcethe use of safety eye protection equipment bythe tool operators and by other persons in theimmediate working area.3. Wear hearing protection to protect your earsagainst exhaust noise and head protection.Also wear light but not loose clothing. Sleevesshould be buttoned or rolled up. No necktieshould be worn.4. Rushing the job or forcing the tool isdangerous. Handle the tool carefully. Do notoperate when under the influence of alcohol,drugs or the like.5. General Tool Handling Guidelines:(1) Always assume that the tool containsfasteners.(2) Do not point the tool toward yourself oranyone whether it contains fasteners ornot.(3) Do not actuate the tool unless the tool isplaced firmly against the workpiece.(4) Respect the tool as a working implement.(5) No horseplay.(6) Do not hold or carry the tool with a fingeron the trigger.(7) Do not load the tool with fasteners whenany one of the operating controls isactivated.(8) Do not operate the tool with any powersource other than that specified in the tooloperating/safety instructions.6. An improperly functioning tool must not beused.7. Sparks sometimes fly when the tool is used.Do not use the tool near volatile, flammablematerials such as gasoline, thinner, paint, gas,adhesives, etc.; they will ignite and explode,causing serious injury.8. The area should be sufficiently illuminated toassure safe operations. The area should beclear and litter-free. Be especially careful tomaintain good footing and balance.9. Only those involved in the work should be inthe vicinity. Children especially must be keptaway at all times.10. There may be local regulations concerningnoise which must be complied with bykeeping noise levels within prescribed limits.In certain cases, shutters should be used tocontain noise.11. Do not play with the contact element: itprevents accidental discharge, so it must bekept on and not removed. Securing the triggerin the ON position is also very dangerous.Never attempt to fasten the trigger. Do notoperate a tool if any portion of the tooloperating controls is inoperable, disconnected,altered, or not working properly.