P 8/13R epair[3] DISASSEMBLY/ASSEMBLYSteel ball 3.5 (2psc.)Compression spring 13Flat washer 12Sleeve Hammer case completeNylon washer 14 AnvilAnvilAssemble in the reverse order of disassembly. (Figs. 19, 18 and 17)SleeveHammer casecompleteAnvilUse 1R232 for holding Sleeve firmlyfor easy removal of Ring spring 11.1R232Ring spring 11[3]-5 Bit Holder Section and Anvil1R232Fig. 19 Fig. 20Fig. 21DISASSEMBLINGASSEMBLING(1) Remove Bumper and Hammer case cover from the machine. (Fig. 2)(2) Separate Housing (R) from Housing (L), then remove Hammer case section from Motor section. (Fig. 3)(3) Remove Bearing box complete from Hammer case complete. (Fig. 4)(4) Separate Hammer case complete. (Fig. 5)(5) Bit holder section and Anvil can now be disassembled (Figs. 19, 20 and 21)Ring spring 11SleeveRaise this side (opposite to the expanded side) with index fingerwhen removing Ring spring 11.Press the top of Sleevewith thumb so as no to allowCompression spring 13to pop out and away.Expand the end gap ofRing spring 11 with 1R291.Flat washer 12, Compression spring 13 andSleeve can now be removed from Anvil.Anvil and Nylon washer 14 can now be removed fromHammer case complete.Be careful not to lose Steel ball 3.5.