Makita DTD148 Technical Product Information

Also see for DTD148: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Wiring diagramP 12/ 14Fig. D-2Wiring in Housing set LSection AStopper of Hammercase completeCaution 1: Be careful not to pinch Lead wires of LED light circuit betweenStopper of Hammer case complete and Housing set.After assembling Hammer case to Housing set L, set the Lead wiresof LED light circuit in place. Be careful about Cautions 1 and 2,and the lead wires of LED light circuit will be put without beingpinched between Stopper of Hammer case complete and Housing set,and between Rib E and Hammer case.Caution 2: Be careful not to putLead wires of LED light circuitbetween Rib E and Hammer case.Slacking of Lead wires from Statorunit should be placedin this space.Route Lead wires betweenRib C and Rib D.Place Lead wires of LED lightcircuit under Lead wires fromStator unit.Sponge attached to the Lead wires mustbe placed so that it comes on the dottedline as drawn above.Do not put any Lead wires on these Ribs.Route Lead wires from Terminal over the projection of Controlleron Housing L side.Fixing Lead wires from Terminalin this lead wire holder is allowedif necessary.LeadwiresRib EPass Lead wires of LED light circuit between Rib A and Boss,between stopper of Hammer case and Rib B, and between Hammercase and F/R change lever.Stator unitRib CProjection of ControllerRib BRib ASwitchF/R ChangeleverThis dotted line meansthe extension of the borderlinebetween Seal and Switch.Do not move the seal fromthe proper position.(Refer to Fig. 18.)Rib DHammer caseStopper ofHammercase completeSection ASealLED lightcircuitBoss

/ 14

Related manuals for Makita DTD148