Makita DTD154 Instruction Manual

Also see for DTD154: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

5 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DTD154Fastening capacities Machine screw 4 mm - 8 mmStandard bolt 5 mm - 16 mmHigh tensile bolt 5 mm - 14 mmNo load speed Hard impact mode 0 - 3,600 min-1Medium impact mode 0 - 2,100 min-1Soft impact mode 0 - 1,100 min-1T mode 0 - 3,600 min-1Impacts per minute Hard impact mode 0 - 3,800 min-1Medium impact mode 0 - 2,600 min-1Soft impact mode 0 - 1,100 min-1T mode 0 - 2,600 min-1Rated voltage D.C. 18 VOverall length 117 mmBattery cartridge BL1815, BL1815N, BL1820,BL1820BBL1830, BL1830B, BL1840,BL1840B, BL1850, BL1850B,BL1860BNet weight 1.2 kg 1.5 kg• Due to our continuing program of research and developmen t, the speciications herein are subject to changewithout notice.• Speciications and battery cartridge may differ from country to country.• Weight, with battery cartridge, according to EPTA-Procedure 01/2003Intended useThe tool is intended for screw driving in wood, metaland plastic.NoiseThe typical A-weighted noise level determined accord-ing to EN60745:Sound pressure level (LpA) : 96 dB(A)Sound power level (LWA) : 107 dB (A)Uncertainty (K) : 3 dB(A)The noise level under working may exceed 80 dB (A).WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN60745:Work mode: impact tightening of fasteners of the maxi -mum capacity of the toolVibration emission (ah) : 12.5 m/s2Uncertainty (K) : 1.5 m/s 2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.