Makita DTD171 Instruction Manual

Also see for DTD171: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

11 ENGLISH2. Press and hold the button and the quickmode-switching button at the same time until the custom-ize lamp and the lamp of desired application mode blinks.[Fig.11: 1. Quick mode-switching button 2. Customize lampNOTE: You can overwrite the current application mode Using the quick mode-switching functionWhen the tool is in the mode that is not registered, press thequick mode-switching button to switch to the registered applica-tion mode. The tool switches between the registered application \ G' jonce when switching to the registered application mode.NOTE: The customize lamp will light up when theapplication mode registered to the tool is chose.Cancelling the quick mode-switching functionPress and hold the button and quick mode-switch-ing button at the same time until the customize lampand all impact force grade lamps blink.NOTE : After cancelling the quick mode-switching function, thequick mode-switching button works for changing the impact force.ASSEMBLYCAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore carrying out any work on the tool.Installing or removing driver bit/socket bit[Fig.12$ % G % G For tool with shallow driver bit holeA=12mmB=9mm$ Follow the procedure 1. (Note)# ' For tool with deep driver bit holeA=17mmB=14mm bits, follow the procedure 1.A=12mmB=9mm bits, follow the procedure 2.!"# ' for installing the bit.Procedure 1For tool without one-touch type sleeve[Fig.13: 1. Driver bit 2. SleeveTo install the driver bit, pull the sleeve in the direction of thearrow and insert the driver bit into the sleeve as far as it will go.Then release the sleeve to secure the driver bit.For tool with one-touch type sleeveTo install the driver bit, insert the driver bit into thesleeve as far as it will go.Procedure 2In addition to Procedure 1, insert the bit-piece into thesleeve with its pointed end facing in.[Fig.14: 1. Driver bit 2. Bit-piece 3. SleeveTo remove the driver bit, pull the sleeve in the directionof the arrow and pull the driver bit out.NOTE: If the driver bit is not inserted deep enough intothe sleeve, the sleeve will not return to its original posi- Y re-inserting the bit according to the instructions above.NOTE:] sleeve and insert it into the sleeve as far as it will go.NOTE: After inserting the driver bit, make sure that it Y Installing hookCAUTION: When installing the hook, always"/;%&/ >? ?/ ";&/> <&[$Q^ Y G [Fig.15: 1. Groove 2. Hook 3. ScrewG This can be installed on either side of the tool. To installthe hook, insert it into a groove in the tool housing oneither side and then secure it with a screw. To remove,loosen the screw and then take it out.OPERATION[Fig.16 \ the kind or size of the screw/bolt, the material of theworkpiece to be fastened, etc. The relation between fas- \ Proper fastening torque for standard boltN•m(kgf•cm)M14M12M10M8M16M14M12M10M8M16140(1428)(1224)(1020)(816)(612)(408)(204)120100806040200 12121. Fastening time (second) 2. Fastening torque