Makita EA3200S Original Instruction Manual

Also see for EA3200S: Instruction manual Instruction manual Original instruction manual Operator's manual Technical information

Makita EA3200S Original Instruction Manual Manual pdf 20 page image

201 Handle2 Cover3 Hood lock (under the hood cap)4 Tubular handle5 Hand guard (release for chain brake)6 Muffler7 Spike bar8 Chain tensioning screw9 Retaining nuts10 Chain catcher11 Sprocket guard12 Adjusting screw for oil pump (bottom side)13 Fuel pump (Primer)14 Identification plate15 Starter grip16 Combination switch (Choke / ON / Stop)17 Throttle lever18 Safety locking button19 Rear hand guard20 Fuel tank cap21 Adjusting screws for carburetor22 Fan housing with starting assembly23 Oil tank cap24 Chain (Blade)25 Guide bar26 Sprocket guard quick tensioner (TLC)6. Denomination of components (Fig. 24)7. PUTTING INTO OPERATION7a. Only for models withfastening nuts on thesprocket guardCAUTION:Before doing any work on the guide bar or chain,always switch off the engine and pull the plug capoff the spark plug (see 8-6 “Replacing the sparkplug”). Always wear protective gloves!CAUTION:Start the chain saw only after having assembled itcompletely and inspected.7a-1. Mounting the guide bar and saw chain(Fig. 25)Use the universal wrench delivered with the chain saw for thefollowing work.Put the chain saw on a stable surface and carry out thefollowing steps for mounting the guide bar and saw chain:Release the chain brake by pulling the hand guard (1) indirection of arrow.Unscrew retaining nuts (2).Pull off the sprocket guard (3).(Fig. 26)Turn chain tensioning screw (4) to the left (counter‑clockwise)until the pin (5) of the chain tensioner is underneath thethreaded pin (6).(Fig. 27)Put on the guide bar (7). Make sure that the pin (5) of the chaintensioner engages in the hole in the guide bar.(Fig. 28)Lift the chain (9) over the sprocket (8).CAUTION:Do not insert the chain between the chain sprocket and thedisc.Guide the chain from above about halfway into the groove (10)on the guide bar.CAUTION:Note that the cutting edges along the top of the chain mustpoint in the direction of the arrow!(Fig. 29)Pull the chain (9) around the sprocket nose (11) of the guidebar in the direction of the arrow.(Fig. 30)Replace the sprocket guard (3).IMPORTANT:Lift the saw chain over the chain catcher (12).Tighten the nuts (2) only hand‑tight to begin with.7a-2. Tightening the saw chain(Fig. 31)Turn the chain tensioning screw (4) to the right (clockwise)until the saw chain catches in the groove on the lower side ofthe guide bar (see circle).Slightly lift the end of the guide bar and turn the chain adjustingscrew (4) to the right (clockwise) until the chain rests againstthe bottom side of the guide bar.While still holding up the tip of the guide bar, tighten theretaining nuts (2) with the universal wrench.7a-3. Checking the chain tension(Fig. 32)The tension of the chain is correct if the chain rests against thebottom side of the guide bar and can still be easily turned byhand.While doing so the chain brake must be released.