Makita EM2600U Owner's And Safety Manual

Also see for EM2600L: Original instruction manual Original instruction manual Original instruction manual Service manual Original instruction manual

Contents

16NYLON CUTTING HEADThe nylon cutting head is a dual line trimmer head that has bump & feedmechanism.The nylon cutting head feeds out the nylon cord after tapping the trimmer headon the ground.Operation– The most effective cutting area is shown by the shaded area.– To feed the nylon cord, increase the nylon cutting head speed to approx.6,000 min-1 and tap the nylon cutting head lightly on the ground.– If the nylon cutting head does not feed out by tapping, rewind/replace thenylon cord by following the procedures described under “Replacing the nyloncord.”Replacing the nylon cord– Stop the engine.– Press the housing latches inward to lift off the cover, then remove the spool.– Hook the center of new nylon cord into the notch in the center of the spool,with one end of the cord extending about 80 mm (3-1/8”) more than the other.Then wind both ends firmly around the spool in the direction of the headrotation (left-hand direction indicated by LH and right-hand direction by RH onthe side of the spool).– Wind all but about 150 mm (6”) of the cords around the spool, leaving the endstemporarily hooked through the notch on the side of the spool.Most effective cutting areaCoverLatchesPressPressSpool 80 mm (3-1/8”)For left handrotationSpool150 mm (6”)Notches