Makita KP001G Instruction Manual

Also see for KP001G: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

17 ENGLISHPlaner blade settingsYour planing surface will end up rough and uneven, unless the planer blades are set properly and securely.Install planer blades correctly so the cutting edges sit in a right angle, on an absolute level with the rear baseline, andexactly parallel to the sole of the plane. Read the examples in the table for proper settings.Planing surface Blade setting CauseCorrect setting(A) (B)(C)Cutting edges sit on a level withthe rear baseline and run sideto side parallel to the sole ofthe plane.Gouging at start(A) (B)(C)Cutting edges underreach therear baseline.Gouging at end(B)(A) (C)Cutting edges overpass therear baseline.Aslope in surface(B)(B)(A)(C)Cutting edges sit side to sideunparalleled to the sole of theplane.(A): Front base (Adjustable shoe)(B): Rear base (Fixed shoe)(C): Planer bladeInstalling guide rule1. Lay the tool down with the belt cover facing upwards.2. Mount the guide rule in place by securing it with thethumb screw into the mounting hole on side of the tool head.► Fig.21: 1. Belt cover 2. Guide rule 3. Thumb screw4. Mounting hole3. Slide the edge fence in and out to your desiredplaning width, and then tighten the thumb screw tosecure it in the required position.► Fig.22: 1. Edge fence 2. Thumb screwInstalling depth guide1. Lay the tool down with the belt cover facing downwards.2. Mount the depth guide in place by securing it withthe washer and thumb screw into the mounting hole onside of the tool head.► Fig.23: 1. Belt cover 2. Depth guide 3. Washer4. Thumb screw 5. Mounting hole3. Slide the depth guide up and down to your desiredplaning depth, and then tighten the thumb screw tosecure it in the required position.► Fig.24: 1. Depth guide 2. Thumb screwInstalling chamfering rulesOptional accessory1. Lay the tool down with the front base facingupwards.2. Attach the edge fences to the mounting arms,aligning the projections on the arms with the guide slitsin the edge fences, and secure them with the washersand thumb screws.3. Mount the chamfering rules (sets of edge fencesand mounting arms) in place by securing them with thethumb screws into the mounting holes on both sides ofthe tool head.► Fig.25: 1. Front base 2. Edge fence 3. Mountingarm 4. Projection 5. Guide slit 6. Washer7. Thumb screw 8. Mounting hole4. Slide the edge fences in and out to your desiredchamfering range, and then tighten the thumb screws tosecure them in the required position.► Fig.26: 1. Edge fence 2. Thumb screw