Makita LS1018 Instruction Manual

Also see for LS1018: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita LS1018 Instruction Manual Manual pdf 19 page image

19Carrying tool011411Make sure that the tool is unplugged. Secure the blade at0° bevel angle and the turn base at the full right miterangle position. Secure the slide poles so that the lowerslide pole is locked in the position of the carriage fullypulled to operator and the upper poles are locked in theposition of the carriage fully pushed forward to the guidefence (refer to the section titled "Slide lock adjustment ".)Lower the handle fully and lock it in the lowered positionby pushing in the stopper pin.Wind the power supply cord using the cord rests.WARNING:• Stopper pin is only for carrying and storagepurposes and should never be used for anycutting operations. The use of the stopper pin forcutting operations may cause unexpectedmovement of the saw blade resulting in kickbackand serious personal injury.Carry the tool by holding both sides of the tool base asshown in the figure. If you remove the holders, dust bag,etc., you can carry the tool more easily.CAUTION:• Always secure all moving portions before carryingthe tool. If portions of the tool move or slide whilebeing carried loss of control or balance may occurresulting in personal injury.MAINTENANCEWARNING:• Always be sure that the tool is switched off andunplugged before attempting to performinspection or maintenance. Failure to unplug andswitch off the tool may result in accidental start up ofthe tool which may result in serious personal injury.• Always be sure that the blade is sharp and cleanfor the best and safest performance. Attempting acut with a dull and /or dirty blade may cause kickbackand result in a serious personal injury.NOTICE:• Never use gasoline, benzine, thinner, alcohol or the like.Discoloration, deformation or cracks may result.Adjusting the cutting angleThis tool is carefully adjusted and aligned at the factory,but rough handling may have affected the alignment. Ifyour tool is not aligned properly, perform the following:1. Miter angle123010410Push the carriage toward the guide fence andtighten the locking screw to secure the carriage.Loosen the grip which secures the turn base. Turn theturn base so that the pointer points to 0° on the miterscale. Then turn the turn base slightly clockwise andcounterclockwise to seat the turn base in the 0° miternotch. (Leave as it is if the pointer does not point to0°.) Loosen the hex sockets bolts securing the guidefence using the socket wrench.12011412Lower the handle fully and lock it in the loweredposition by pushing in the stopper pin. Square theside of the blade with the face of the guide fenceusing a triangular rule, try-square, etc. Thensecurely tighten the hex socket bolts on the guidefence in order starting from the right side.123010253Make sure that the pointer points to 0° on the miterscale. If the pointer does not point to 0°, loosen thescrew which secures the pointer and adjust thepointer so that it will point to 0°.1. Screw2. Pointer3. Miter scale1. Guide fence2. Triangular rule1. Hex bolt2. Guide fence3. Grip

/ 24

Related manuals for Makita LS1018

Makita LS1018 Instruction Manual

This manual is suitable for:

LS1018 LS1018L

manualsdatabase

Your AI-powered manual search engine