Makita LS1030N Instruction Manual

Also see for LS1030N: Instruction manual Instruction manual Parts Breakdown Instruction manual Instruction manual

Contents

151. Press cuttingSecure the workpiece with the vise. Switch on the toolwithout the blade making any contact and wait until theblade attains full speed before lowering. Then gentlylower the handle to the fully lowered position to cut theworkpiece. When the cut is completed, switch off the tooland WAIT UNTIL THE BLADE HAS COME TO A COM-PLETE STOP before returning the blade to its fully ele-vated position.2. Miter cuttingRefer to the previously covered “Adjusting the miterangle”.3. Cutting crown and cove moldingsThere are two common types of crown moldings and onetype of cove moldings; 52/38° wall angle crown molding,45° wall angle crown molding and 45° wall angle covemolding. See illustrations.There are crown and cove molding joints which aremade to fit “Inside” 90° corners ((1) and (2) in Fig. A) and“Outside” 90° corners ((3) and (4) in Fig. A).MeasuringMeasure the wall length and adjust workpiece on table tocut wall contact edge to desired length. Always makesure that cut workpiece length at the back of the work-piece is the same as wall length. Adjust cut length forangle of cut. Always use several pieces for test cuts tocheck the saw angles.0017881. 52/38° type crown molding2. 45° type crown molding3. 45° type cove molding52∞38∞45∞45∞45∞45∞1 2 30015551. Inside corner2. Outside corner1. Inside corner2. Outside corner(1) (2) (3) (4)1 2Fig.A0015562(1)(2)(1)(2)(2)(1)(2)(1)(1)(2)(3)(4)1001557