Makita LS1030N Instruction Manual

Also see for LS1030N: Instruction manual Instruction manual Parts Breakdown Instruction manual Instruction manual

Contents

17CAUTION:• Use straight wood of even thickness as the wood facing.• Use screws to attach the wood facing to the guide fence.The screws should be installed so that the screw headsare below the surface of the wood facing.• When the wood facing is attached, do not turn the turnbase with the handle lowered. The blade and/or thewood facing will be damaged.6. Cutting repetitive lengthsWhen cutting several pieces of stock to the same length,ranging from 240 mm (9 - 29/64”) to 400 mm (15 - 3/4”),use of the set plate (optional accessory) will facilitatemore efficient operation. Install the set plate on theholder (optional accessory) as shown in the figure.Align the cutting line on your workpiece with either theleft or right side of the groove in the kerf board, and whileholding the workpiece from moving, move the set plateflush against the end of the workpiece. Then secure theset plate with the screw. When the set plate is not used,loosen the screw and turn the set plate out of the way.NOTE:• Use of the holder-rod assembly (optional accessory)allows cutting repetitive lengths up to 2,200 mm (7.2 ft.)approximately.1. HoleOver 10mm (3/8”) Over 460mm (18-1/8”)1 190mm (3-9/16”)40mm (1-9/16”)137mm(5-3/8”)70mm(2-3/4”)137mm(5-3/8”)70mm(2-3/4”)0017791. Set plate2. Holder3. Screw123001846