Makita LS1040 Instruction Manual

Also see for LS1040: Instruction manual Instruction manual Parts Breakdown Instruction manual Instruction manual

Contents

15the projection may stop at an angle. In this case, turn the viseknob back counterclockwise until the screw is released,before turning again gently clockwise.The maximum width of the workpiece which can be securedby the horizontal vise is 130 mm (5 - 1/8”).CAUTION:• Grip the workpiece only when the projection is at thetopmost position. Failure to do so may result ininsufficient securing of the workpiece. This could causethe workpiece to be thrown, cause damage to the bladeor cause the loss of control, which can result inPERSONAL INJURY.Holders and holder assembly (optionalaccessories)The holders and the holder assembly can be installed oneither side as a convenient means of supporting workpieceshorizontally. Install them as shown in the figure. Then tightenthe screws firmly to secure the holders and the holderassembly.When cutting long workpieces, use the holder-rod assembly(optional accessory). It consists of two holder assembliesand two rods 12.CAUTION:• Always support long workpieces level with the topsurface of the turn base for accurate cuts and to preventdangerous loss of control of the tool.OPERATION CAUTION:• Before use, be sure to release the handle from thelowered position by pulling the stopper pin.• Make sure the blade is not contacting the workpiece, etc.before the switch is turned on.1. Holder2. Holder assembly1 20022471. Holder assembly2. Rod 1221002246

/ 32

Related manuals for Makita LS1040

Makita LS1040 Instruction Manual

This manual is suitable for:

LS1040

manualsdatabase

Your AI-powered manual search engine