Makita LS1040 Instruction Manual

Also see for LS1040: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

18(2) 45° bevel angleAdjust the 45° bevel angle only after performing 0° bevel angleadjustment. To adjust left 45° bevel angle, loosen the lever and tiltthe blade to the left fully. Make sure that the pointer on the armpoints to 45° on the bevel scale on the arm. If the pointer does notpoint to 45°, turn the 45° bevel angle adjusting bolt on the left sideof the arm until the pointer points to 45°.Replacing carbon brushesRemove and check the carbon brushes regularly. Replace when they weardown to the limit mark. Keep the carbon brushes clean and free to slip in theholders. Both carbon brushes should be replaced at the same time. Use onlyidentical carbon brushes.Use a screwdriver to remove the brush holder caps. Take out the worn carbonbrushes, insert the new ones and secure the brush holder caps.After use• After use, wipe off chips and dust adhering to the tool with a cloth or thelike. Keep the blade guard clean according to the directions in thepreviously covered section titled “Blade guard”. Lubricate the slidingportions with machine oil to prevent rust.To maintain product SAFETY and RELIABILITY, repairs, any other mainte-nance or adjustment should be performed by Makita Authorized Service Cent-ers, always using Makita replacement parts.1. Lever2. Arm3. Pointer4. 45° bevel angle adjusting bolt12 340017701. Limit mark10011451. Screwdriver2. Brush holder cap1 2001772

/ 20

Related manuals for Makita LS1040

Makita LS1040 Instruction Manual

This manual is suitable for:

LS1040 LS1040S

manualsdatabase

Your AI-powered manual search engine